How to Reset Brother DCP-J140W Printer Machine Error 46

Ruangngoprek.web.id    –  How to Reset Brother DCP-J140W Printer Machine Error 46.  Maybe among friends who have a Brother printer with the DCP-J140W type, there are those who have experienced the same thing as me, namely when the printer is turned on, an error message machine error 46 appears, initially I did not know the problem, but after I found out on the internet, it turned out that the brother printer was experiencing a problem with the Ink Counter being full, so that when the printer was turned on, an error message machine 46 appeared. Unlike other types of printers such as Canon or Epson which use software to reset it, but the Brother DCP-J140W printer to reset it only uses the Buttons and Codes on the brother printer itself.

For those of you who don't know how to reset the Brother DCP-J140W printer with the error message "machine error 46", you can follow the steps below.

How to Reset Brother DCP-J140W Printer Machine Error 46

• Unplug the power cable first, press and hold the menu button, while pressing the menu button (do not release it) then plug the power cable into the electricity.
• Then an error message will appear "Machine Error 46", just ignore the error message.
• After that, press the up arrow button ^ until the screen shows the number 8, then press OK.
• Press the up arrow key again ^ until the screen shows the number 0, then press ok
• After that, the printer will enter save mode, then press the “Mono” button, press it several times until the screen shows the “Purge Counter Appear” menu.
• Then press the up arrow button again ^ until the screen shows the number 2, then press OK.

• Press the up arrow button again ^ until the screen shows the number 7, then press OK.
• Press the up arrow button again ^ until the screen shows the number 8, then press OK.
• Press the up arrow button again ^ until the screen shows the number 3, then press OK.
• Then Purge will be reset marked with the number on Purge: 0000
• Press the “exit/stop” button to exit printer save mode.
• There will be a “Machine Error 46” message again, just ignore that message.
• Then press the up arrow ^ until the screen shows the number 9, then press OK.
• Press the up arrow ^ again until the screen shows the number 9, then press OK.
• The printer will wait for a while, after which the printer will be ready to use again.

That's   how to reset the Brother DCP-J140W printer machine error 46   which displays the error message "machine error 46", hopefully this article can help those of you who are looking for a solution to the error on the Brother printer, good luck.